Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

Biogenic palladium prepared by activated sludge microbes for the hexavalent chromium catalytic reduction: Impact of relative biomass

• Pd nanoparticles could be reduced and supported by activated sludge microbes. • The effect of biomass on Pd adsorption by microbes is greater than Pd reduction. • More biomass reduces Pd particle size, which is more dispersed on the cell surface. • When the biomass/Pd add to 6, the catalytic reduction rate of Cr(VI) reaches stable. Palladium, a kind of platinum group metal, owns catalytic capacity for a variety of hydrogenations. In this study, Pd nanoparticles (PdNPs) were generated through enzymatic recovery by microbes of activated sludge at various biomass/Pd, and further used for the Cr(VI) reduction. The results show that biomass had a strong adsorption capacity for Pd(II), which was 17.25 mg Pd/g sludge. The XRD and TEM-EDX results confirmed the existence of PdNPs associated with microbes (bio-Pd). The increase of biomass had little effect on the reduction rate of Pd(II), but it could cause decreasing particle size and shifting location of Pd(0) with the better dispersion degree on the cell surface. In the Cr(VI) reduction experiments, Cr(VI) was first adsorbed on bio-Pd with hydrogen and then reduced using active hydrogen as electron donor. Biomass improved the catalytic activity of PdNPs. When the biomass/Pd (w/w) ratio increased to six or higher, Cr(VI) reduction achieved maximum rate that 50 mg/L of Cr(VI) could be rapidly reduced in one minute.     

腐殖酸对砂质土壤吸附Cr(VI)的影响

利用系列摇瓶振荡实验,研究了在砂质土壤介质中腐殖酸(HA)对Cr(VI)还原作用及增强土壤表面对其吸附的影响.通过改变反应接触时间、pH值、HA投加量等条件,确定了最佳吸附反应条件.结果表明:砂质土壤中存在HA时,可使Cr(VI)还原为毒性较小的Cr(Ⅲ),明显增强土壤对可溶态Cr离子的吸附能力,比同等条件下无HA的土壤吸附量增大1倍以上.一般整个反应过程约8 h即可达到稳定.pH值对Cr的还原和吸附有很大的影响,酸性条件下的吸附量比碱性条件可增大1倍,最佳pH值为2～4;当pH＞5时吸附能力急剧下降,pH=10时吸附去除量降为20%.有HA存在时砂质土壤土对Cr(VI)的吸附反应为一级动力学反应,K298=0.033 5 min-1,砂土对CrO2-4的等温吸附曲线较好地满足Langmuir公式.     

改性氢氧化镁制备及其去除地下水中Cr3+性能研究

氢氧化镁作为一种可缓慢释放OH-的碱,能使多数重金属离子转换为沉淀,而且不会引起太大的pH变化.但氢氧化镁难溶于水,在含水层中的迁移能力很差.若要用于地下水重金属污染修复,需要对氢氧化镁进行改性.因此,本文利用表面活性剂对氢氧化镁粉末进行改性,合成了氢氧化镁胶体,并对改性氢氧化镁的稳定性、粒度及其对Cr3+的稳定化效果进行了分析.结果表明,复配表面活性剂改性的氢氧化镁悬浮液稳定性好,粒径小,0.6~8.4μm的颗粒占82.41%.利用改性氢氧化镁对Cr3+污染地下水进行处理,其对Cr3+的去除机理主要为沉淀反应,氢氧化镁和Cr3+反应的质量比约为1.333∶1,氢氧化镁和初始Cr3+浓度对Cr3+的去除效果都有较大的影响.     

运行参数对水蚯蚓生物吸持六价铬性能影响研究

水蚯蚓能通过摄食剩余污泥而使污泥减量,但剩余污泥中常含有各种重金属污染物.本文以颤蚓科蠕虫(Tubificidae)为研究对象,以六价铬为典型重金属污染物,考察运行工艺参数:初始铬浓度、p H、水蚯蚓投加量和温度对水蚯蚓吸持六价铬的影响.实验结果表明,在研究浓度范围内(0.1~8.0 mg·L-1),水蚯蚓对六价铬的吸持速率随铬浓度的增大而加快,单位质量吸持量从14.4 mg·kg-1(以干重计,下同)增加到312.7 mg·kg-1,但六价铬的吸持率却随Cr6+初始浓度的增加而降低;p H从6.0增加到8.0,水蚯蚓对六价铬的吸持速率随p H的上升而提高,吸持率和单位质量吸持量先明显增强,p H达到7.5后逐渐趋于平衡,即吸持最佳p H为7.5;水蚯蚓投加量从1.0 g(以湿重计,下同)增加到5.0 g时,吸持速率及吸持率均上升,但单位质量吸持量却随着水蚯蚓投加量的增加而减少;当温度在10~20℃范围内时,水蚯蚓对六价铬的吸持速率相对较慢,到25℃时,吸持速率明显加快,吸持率和单位质量水蚯蚓的吸持量的变化趋势与吸持速率的变化相一致,但当温度达到30℃,水蚯蚓会大量死亡,综合考虑,处理系统最佳温度宜控制在25℃.     

Simultaneous photocatalytic treatment of Cr(VI), Ni(II) and SDBS in aqueous solutions: Evaluation of removal efficiency and energy consumption

Simultaneous photocatalytic reduction of poisonous Cr(VI) and Ni(II) ions, coupled with photocatalytic oxidation of sodium dodecyl benzene sulfonate (SDBS) were studied with a trace amount of commercial titania nanoparticles and by means of a direct-photo-irradiation reactor. The co-presence of metal ions and SDBS causes metal ions reduction as well as SDBS oxidation to enhance and energy efficiency to improve. XRD, XPS and FTIR analysis were used to characterize TiO₂ particles before and after usage with the aim of evaluating the mechanism of reactions. The effect of major operating parameters, pH and temperature, was investigated. Under conditions of [Cr(VI)]₀ = [Ni(II)]₀ = 5 mg/L, [SDBS]₀ = 10 mg/L, [TiO₂] = 40 mg/L, pH 6 and T = 35 °C; the removal efficiencies of 55.4%, 71.2% and 57.2% were obtained, respectively, for Cr(VI) and Ni(II) reduction, as well as for SDBS oxidation, after 110 min operation. The relevant kinetic model jointed with the Arrhenius equation was introduced. Pseudo-first-order reactions are relevant. Energy consumption (electrical and thermal) evaluations revealed that operations at higher temperatures provide significant cost reduction. Meantime, a criterion was proposed for a consistent assessment of this kind of processes.     

铬渣中铬的浸出行为

采用BCR法连续浸提研究铬渣中铬的存在形态,结果表明:铬渣中总铬和六价铬主要以残渣态和可氧化态形式存在;通过铬渣动态连续浸提实验与静态浸提实验研究了浸提剂和活性炭对铬渣中铬浸出行为的影响,研究发现p H值为3.1的醋酸浸提剂浸出液中铬浓度最低,且添加活性炭后的静态浸出液中铬的浓度有不同程度降低。     

碱熔融—微波晶化法合成粉煤灰沸石及其对Cd2+的吸附

以粉煤灰为主要原料，采用碱熔融—微波晶化法合成粉煤灰沸石。采用XRD，SEM，TEM等技术表征了粉煤灰沸石的微观结构，并对其吸附Cd²⁺的性能进行了研究。表征结果显示，粉煤灰沸石主要由X型沸石、P型沸石和铝组成，粉煤灰沸石中有排列规则、呈蜂窝状的孔穴和孔道存在，其孔穴和孔道大小分布均匀，致密。粉煤灰沸石的比表面积为108.49 m²/g，平均孔径为3.779 nm，孔体积为0.221 mL/g。实验结果表明，在溶液pH为7、吸附时间30 min的最佳吸附条件下，Cd²⁺去除率均大于94%。粉煤灰沸石对Cd²⁺的吸附可很好地用二级动力学方程进行拟合，相关系数为0.999 99。可用Langmuir等温吸附模型描述该吸附过程，该吸附过程是单分子层吸附，主要是化学吸附，粉煤灰沸石对Cd²⁺的饱和吸附量为49.261 mg/g。     

中和共沉淀—铁氧体法处理含镍、铬废水的实验研究

利用中和共沉淀—铁氧体法处理甘肃某稀有金属生产企业产生的含镍、铬废水,同时对该废水的处理工艺条件进行了实验研究。经测定,废水中Ni 2+质量浓度为50mg/L,Cr(Ⅲ)质量浓度为87mg/L。通过实验得到处理工艺的最佳条件:投料摩尔比(Fe2+/(Ni 2++Cr2O2-7))为9,pH=9,温度为70℃。出水中镍、铬均可达到《污水综合排放标准》(GB 8978—1996)中第一类污染物最高允许排放浓度的要求,为中和共沉淀—铁氧体法处理混合重金属废水的工艺条件研究提供了参考。     

磁性生物炭负载Mg-Fe水滑石的制备及其吸附水中Cd（Ⅱ）和Ni（Ⅱ）的性能

合成了一种高吸附容量的磁性生物炭负载Mg-Fe水滑石复合材料（L-BC）,并用于去除水中的Cd²⁺和Ni²⁺。表征结果表明,采用浸渍联合热解法成功制备了磁性生物炭（M-BC）,水热合成法成功地将Mg-Fe水滑石负载在M-BC上。动力学研究结果表明,Cd²⁺和Ni²⁺吸附符合伪二级动力学模型,化学吸附为速率控制步骤。等温吸附研究结果表明,L-BC对Cd²⁺和Ni²⁺的吸附符合Langmuir模型,为单分子层化学吸附,最大吸附量分别为263.156 mg/g和43.291 mg/g。吸附机理主要为Mg-Fe水滑石层间CO₃^2-和表面羟基与Cd²⁺和Ni²⁺产生表面共沉淀。L-BC具有良好的吸附和重复利用性能,是一种很有前景的去除Cd²⁺和Ni²⁺的吸附材料。